Subject	Heh, couldn't resist. Bernie, still got that short block?
Posted by	yobobrox on May 27, 2009 at 6:21 PM
	This message has been viewed 230 times.
In Reply To	What hoseline 2 oil goes in this from pan toturbo???Finland! posted by yobobrox on May 27, 2009 at 05:37 PM
Message	I finally figured out what was wrong with this motor. I'm still amazed that the car ran. Unfortunately, I don't think Kyle is going to count this for a core...just a guess. Here are some more pictures: Sure was easy to get this piston out. Nice and compact - for easy carrying! Stress fractures. Down the cylinder. Hmm...I think something is missing from the casting... I should have taken a few shots of the rod itself (or what's left of it on the crank). Any ideas on what caused this? Nothing that I know about makes any sense with this car - this occurred under almost zero acceleration at low rpms approximately 1/4 mile after departure. And the car was driven back the 1/4 mile after this happened, minus a lot of oil.
Follow Ups	What hoseline 2 oil goes in this from pan toturbo???Finland! - yobobrox 17:37:20 05/27/09 Heh, couldn't resist. Bernie, still got that short block? - yobobrox 18:21:19 05/27/09 You spun a rob bearing. - Timmay 19:37:16 05/27/09 I was thinking that too, but from visual inspection - yobobrox 21:31:27 05/27/09 Oh Snap! (n/m) - Spddracer 21:20:15 05/27/09 So long as I don't "Snap-On" :D (n/m) - yobobrox 21:29:49 05/27/09 that doesn't look quite right (n/m) - aliaZ 22:13:39 05/27/09 bondo (n/m) - ZiNnYc 01:21:23 05/28/09 how much psi ? (n/m) - zxautogiro 00:16:23 05/28/09 When it happened, psi was below 8. (n/m) - yobobrox 09:47:14 05/28/09
Post a Followup	You cannot reply to this message because you are not logged in.