Subject	Checked and I have zero boost leaks.
Posted by	jmw23712 on May 26, 2009 at 9:44 PM
	This message has been viewed 86 times.
In Reply To	Checked for boost leaks? posted by ZCulture on May 26, 2009 at 04:57 PM
Message	I mean none. I pressurized the system to about 3psi, went inside and went to the bathroom, came back put and it was still over 1psi.
Follow Ups	GReddy Profec Boost Solenoid. - jmw23712 09:13:05 05/26/09 You can use a Perrin solenoid. (n/m) - Woody75 (Denver) 09:29:07 05/26/09 As in this? - jmw23712 09:37:23 05/26/09 Yepper. (n/m) - Woody75 (Denver) 09:39:33 05/26/09 Yep - zgene4 09:45:33 05/26/09 Cool, Thanks guys. I am going to try to fix mine and - jmw23712 09:52:08 05/26/09 On a side note. - Josher 10:55:49 05/26/09 I don't know for sure but I have called around and I - jmw23712 11:11:52 05/26/09 I keep getting a misfire under boost. - Josher 11:29:09 05/26/09 Are you sure it is even boost controller related? (n/m) - jmw23712 11:56:42 05/26/09 Not positive. - Josher 12:23:44 05/26/09 That is strange but it doesn't sound like your BC to me. - jmw23712 14:17:41 05/26/09 They are brand new. - Josher 15:13:07 05/26/09 That's a tough one then. I still don't think it's the BC. (n/m) - jmw23712 21:50:35 05/26/09 Check your CAS timing, make sure it's not too far advanced - BigTDogg (MA) 22:12:38 05/26/09 Interesting. I had it set when I first did the swap. - Josher 12:22:38 05/27/09 It's a possible cause of your issue, and easy to check - BigTDogg (MA) 13:57:29 05/27/09 I repaired my Blitz - ZCulture 12:58:36 05/26/09 That's the post I was looking for. - jmw23712 14:57:56 05/26/09 Here, - Faisal 16:03:59 05/26/09 I actually did that earlier. - jmw23712 21:44:57 05/26/09 Checked for boost leaks? - ZCulture 16:57:44 05/26/09 Checked and I have zero boost leaks. - jmw23712 21:44:01 05/26/09 You can get a GM solenoid. - apudapus 01:27:45 05/27/09
Post a Followup	You cannot reply to this message because you are not logged in.