Subject	Reboring cylinders with a Sunnen honing machine: is it good?
Posted by	Dark Diver on May 26, 2009 at 6:30 AM
	This message has been viewed 212 times.
Message	I'm currently in the market to get my engine rebored (from 87.0mm to 87.5mm). I found a machinist not far from me, who uses a honing machine from Sunnen, this one I believe : http://sunnen.com/ProductDetails.aspx?ProductID=50&NavID=655 The guy told me this was the best machine to use for that job because it "gently" rebores the cylinders, is auto-centering, is very precise (you stop the honing process as soon as you get the target bore)... Opinion are welcomed since I don't have any experience on this subject. Thanks.
Follow Ups	Reboring cylinders with a Sunnen honing machine: is it good? - Dark Diver 06:30:35 05/26/09 I have no experience with that hone, but I honed my engine - na300zx (OH) 06:36:19 05/26/09 There is a difference between "boring" and "honing" - LitlElvis 06:36:46 05/26/09 Yes, that's what I told to the machinist. - Dark Diver 07:01:05 05/26/09 With 70 grit stones (what I started with) - na300zx (OH) 07:03:50 05/26/09 Nothing wrong with Sunnen hones (n/m) - RICH1 06:54:36 05/26/09 Even for a boring (+ honing) process ? (n/m) - Dark Diver 07:01:38 05/26/09 Should still work fine your only removing 0.020" (n/m) - RICH1 07:53:10 05/26/09 OK, thanks. The guy is working on sport cars so I hope - Dark Diver 08:37:37 05/26/09
Post a Followup	You cannot reply to this message because you are not logged in.