Subject	Make some eggs!
Posted by	Carlos Ramirez on May 25, 2009 at 8:47 PM
	This message has been viewed 139 times.
In Reply To	hot intercoolers posted by ricky6991 on May 25, 2009 at 08:27 PM
Message	Intercoolers are about flow, surface area, and fin count so bottom line is have two fans pushed up against the intercoolers when doing a dyno run. if that still not keeping them cool, then make sure you have good ducting to force all the air thru them, and louver your fender liner so that you have a way for the hot air to make it out. Another solution is an alcohol or water spraying the intercoolers and finally ofcourse there is spraying the intercoolers with nitrous. And finally remember that you will always have better results on the street than you will sitting at some dyno.
Follow Ups	hot intercoolers - ricky6991 20:27:59 05/25/09 Make some eggs! - Carlos Ramirez 20:47:40 05/25/09 Re: Make some eggs! - ricky6991 21:04:33 05/25/09 have you looked into water/methanol? - gt300zxtt 21:21:32 05/25/09 Re: have you looked into water/methanol? - ricky6991 21:33:07 05/25/09 go to a dyno operator that knows what they are doing (n/m) - LJZTT 21:35:04 05/25/09 x2. - MixManMash 21:38:01 05/25/09 not quite (n/m) - gt300zxtt 21:35:48 05/25/09 You have more reading to do about water injection. (n/m) - SactoTodd 22:56:36 05/25/09 First of all, why not upgrade your cooling system? Honestly - MixManMash 21:43:12 05/25/09 its not about the dyno though - ricky6991 22:30:15 05/25/09 Intercoolers dont work very well with no airflow - -JK- 22:37:24 05/25/09 i wouldnt need to justify me spending money to anyone online - ricky6991 22:59:58 05/25/09 Do it! Just upgrade the radiator and install a lower - MixManMash 23:33:13 05/25/09 I didn't know - Pilot.P (NZ) 23:35:59 05/25/09 My issue with them is you add a coupler and 2 clamping - TriniTT 23:44:30 05/25/09 Use T-bolt clamps and be done with. (n/m) - MixManMash 07:31:50 05/26/09 Yep. I did that and have had zero issues. (n/m) - Guapo 09:50:42 05/26/09 Sure it has a cooling function versus stock. - MixManMash 07:37:19 05/26/09 Aren't you pushing stock turbos pretty hard at 14psi thus - jmt-z 11:07:05 05/26/09 P.S. with your GT675rs's your intake will be cooler at those - jmt-z 11:08:43 05/26/09 14 psi is pretty standard with a JWT Stage III ECU upgrade. (n/m) - MixManMash 12:26:20 05/26/09 ??? - ZLover4Life 12:38:29 05/26/09 Like I said it has been a long time since I have read - jmt-z 13:28:31 05/26/09 ok, but if it's been a long time and you didn't remember... - ZLover4Life 15:32:53 05/26/09 I remembered wrong apparently. Not like I was spouting off - jmt-z 08:32:21 05/27/09
Post a Followup	You cannot reply to this message because you are not logged in.