Subject	There was an easier way..
Posted by	DEVILS Z-Tech (CA) on May 23, 2009 at 9:56 PM
	This message has been viewed 77 times.
In Reply To	PS problem fixed. posted by DVDBURN (MD) on May 23, 2009 at 08:32 PM
Message	You could have hooked up a PS pressure analyzer and tested the system. Basically the pressure readings will tell you if the pump is bad or the rack is bad. Its a test of the hydraulics. If both of those are good but you are still having problems then it has be something other than the rack and ps pump. I would then test the pressures in the hicas rack.
Follow Ups	PS problem fixed. - DVDBURN (MD) 20:32:57 05/23/09 good job on that - aliaZ 20:35:47 05/23/09 Thanks. - DVDBURN (MD) 21:34:39 05/23/09 There was an easier way.. - DEVILS Z-Tech (CA) 21:56:15 05/23/09 (runs off to grab his power-steering-pressure-analyzer) (n/m) - BobbyT 22:02:38 05/23/09 Whew, I thought I was the only one that had one. :-) (n/m) - Josher 22:50:34 05/23/09 I saw that in the FSM. - DVDBURN (MD) 22:55:11 05/23/09 That would have been your easiest bet but - DEVILS Z-Tech (CA) 23:16:12 05/23/09 You guys are too funny sometimes but - DEVILS Z-Tech (CA) 23:14:42 05/23/09 Wow!! Only $600..everyone should have one - twinturbineZ 02:06:45 05/24/09 Re: PS problem fixed. - ouikikazz 07:12:05 05/24/09 Re: Re: PS problem fixed. - DEVILS Z-Tech (CA) 18:38:21 05/24/09
Post a Followup	You cannot reply to this message because you are not logged in.