Subject	Re: Oring info
Posted by	spdrmn15 on May 21, 2009 at 10:27 PM
	This message has been viewed 115 times.
In Reply To	Oring info posted by icsamerica on May 21, 2009 at 07:43 PM
Message	Does anyone know how much that might cost? I'm assuming they'd have to put a groove around the cylinders and all the coolant/oil passages. This sounds like it could be quite expensive. "Face it, you just can't beat stupid." "Never underestimate the power of stupid people in large groups" "Really there's nothing funnier then slapping someone in the face with someone else's dick"
Follow Ups	O-ring'd block - spdrmn15 17:07:44 05/21/09 Re: O-ring'd block - Tech@EPR 17:37:43 05/21/09 1500 hp vg30dett? (n/m) - yobobrox 20:20:30 05/21/09 Re: 1500 hp vg30dett? - Tech@EPR 21:59:52 05/21/09 hope you're not using the oem crank (n/m) - aliaZ 00:35:51 05/22/09 Re: hope you're not using the oem crank - Tech@EPR 00:43:44 05/22/09 Re: Re: hope you're not using the oem crank - aliaZ 07:20:16 05/22/09 Re: Re: Re: hope you're not using the oem crank - Tech@EPR 09:12:10 05/22/09 side note, was the head gasket your problem? (n/m) - zgene4 18:09:11 05/21/09 Re: side note, was the head gasket your problem? - spdrmn15 18:48:12 05/21/09 so what causes that, gasket material failure, bad seating - zgene4 19:16:49 05/21/09 Re: so what causes that, gasket material failure, bad seating - spdrmn15 22:24:56 05/21/09 Oring info - icsamerica 19:43:42 05/21/09 Re: Oring info - Tech@EPR 21:59:40 05/21/09 Re: Oring info - spdrmn15 22:27:11 05/21/09 Re: Re: Oring info - Tech@EPR 23:39:36 05/21/09 for your mods, o-ringing your block is a waste of money (n/m) - aliaZ 00:33:13 05/22/09 Here are some pics of how I o-ringed my block - LitlElvis 01:23:12 05/22/09 Re: Here are some pics of how I o-ringed my block - Tech@EPR 01:28:25 05/22/09 Nice; good pics (n/m) - yobobrox 09:12:06 05/22/09 you got email (n/m) - Ahmed (Chicago) 09:57:24 05/22/09
Post a Followup	You cannot reply to this message because you are not logged in.