 |
   |
|
| |
|
|
| Subject |
Re: so what causes that, gasket material failure, bad seating |
|
| |
|
|
| Posted by |
spdrmn15 on May 21, 2009 at 10:24 PM |
|
| |
This message has been viewed 96 times. |
|
| |
|
|
| In Reply To |
so what causes that, gasket material failure, bad seating posted by zgene4 on May 21, 2009 at 07:16 PM |
|
| |
|
|
| Message |
I'm not sure, I know I torqued everything to spec, and it can really only go on one way. The only thing I can think of is I had the head on and torqued then had to pull it back off to get a lifter that somehow was stuck out, and since it hadn't been used at all I put it back together with the same gasket. I know you're supposed to put a new one on there every time the head comes off, but I didn't think it'd be necessary. I guess I was wrong.
"Face it, you just can't beat stupid."
"Never underestimate the power of stupid people in large groups"
"Really there's nothing funnier then slapping someone in the face with someone else's dick" |
|
| |
|
|
| Follow Ups |
|
|
| |
|
|
Post a
Followup |
You cannot reply to this message because you are not logged in.
|
|
| |
|
|
| |
|
|
|
