Subject	There is a wax stuff you can buy as well
Posted by	collegeboy on May 17, 2009 at 3:00 PM
	This message has been viewed 96 times.
In Reply To	What have you guys used to grind the aluminum bell housing posted by ChrisZTT (Sacto, CA) on May 17, 2009 at 01:23 AM
Message	It's made specifically for grinding tools and you basically stick the bit in it to get the wax all over the bit, then grind away. The shavings get stuck in the wax instead of gumming up the bit itself. Then you just have to wipe the wax off occasionally and reapply. It will save a ton of bits and money, and I've always gotten it from the same place I buy my bits from. Thanks, Mike 1991 Black 3.0 Twin Turbo La-Z-Link ^^Hard engine break in method^^ La-Z-Link ^^MY FACEBOOK...CHECK IT OUT^^ ---Me: You bought a Porsche? ---sfpearl300z: lol, no no, I have a decent sized penis so no need for that. "felt wierd fingering my exhuast for 1hr with no results :(" - zboost "lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z "I think I'll pass on giving my car a handjob" - joel(PA) "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21
Follow Ups	What have you guys used to grind the aluminum bell housing - ChrisZTT (Sacto, CA) 01:23:54 05/17/09 If you're using a stone..you have to dress it.. (n/m) - twinturbineZ 02:24:09 05/17/09 see inside - twinturbineZ 03:17:36 05/17/09 just use an angle grinder - spyhunterTT(nj) 06:15:28 05/17/09 Dremel 115 High Speed Cutter - Guapo 08:56:35 05/17/09 Buy aluminum disks - -JK- 09:51:05 05/17/09 Yup, that is what I am using. Thanks for all the ideas guys (n/m) - ChrisZTT (Sacto, CA) 12:32:06 05/17/09 There is a wax stuff you can buy as well - collegeboy 15:00:13 05/17/09
Post a Followup	You cannot reply to this message because you are not logged in.