Subject	Yup, that is what I am using. Thanks for all the ideas guys (n/m)
Posted by	ChrisZTT (Sacto, CA) on May 17, 2009 at 12:32 PM
	This message has been viewed 49 times.
In Reply To	Buy aluminum disks posted by -JK- on May 17, 2009 at 09:51 AM
Message
Follow Ups	What have you guys used to grind the aluminum bell housing - ChrisZTT (Sacto, CA) 01:23:54 05/17/09 If you're using a stone..you have to dress it.. (n/m) - twinturbineZ 02:24:09 05/17/09 see inside - twinturbineZ 03:17:36 05/17/09 just use an angle grinder - spyhunterTT(nj) 06:15:28 05/17/09 Dremel 115 High Speed Cutter - Guapo 08:56:35 05/17/09 Buy aluminum disks - -JK- 09:51:05 05/17/09 Yup, that is what I am using. Thanks for all the ideas guys (n/m) - ChrisZTT (Sacto, CA) 12:32:06 05/17/09 There is a wax stuff you can buy as well - collegeboy 15:00:13 05/17/09
Post a Followup	You cannot reply to this message because you are not logged in.