Subject	If you're using a stone..you have to dress it.. (n/m)
Posted by	twinturbineZ on May 17, 2009 at 2:24 AM
	This message has been viewed 56 times.
In Reply To	What have you guys used to grind the aluminum bell housing posted by ChrisZTT (Sacto, CA) on May 17, 2009 at 01:23 AM
Message
Follow Ups	What have you guys used to grind the aluminum bell housing - ChrisZTT (Sacto, CA) 01:23:54 05/17/09 If you're using a stone..you have to dress it.. (n/m) - twinturbineZ 02:24:09 05/17/09 see inside - twinturbineZ 03:17:36 05/17/09 just use an angle grinder - spyhunterTT(nj) 06:15:28 05/17/09 Dremel 115 High Speed Cutter - Guapo 08:56:35 05/17/09 Buy aluminum disks - -JK- 09:51:05 05/17/09 Yup, that is what I am using. Thanks for all the ideas guys (n/m) - ChrisZTT (Sacto, CA) 12:32:06 05/17/09 There is a wax stuff you can buy as well - collegeboy 15:00:13 05/17/09
Post a Followup	You cannot reply to this message because you are not logged in.