TwinTurbo.NET: Nissan 300ZX forum - Brake-man pad opinions?
People Seeking Info
 
   


     
Subject Brake-man pad opinions?
     
Posted by Keaner on May 12, 2009 at 7:30 PM
  This message has been viewed 699 times.
     
     
Message So, I just ran PIR for the first time and ended up burning through a set of the AXIS/PBR metal-masters I think it was. Overall, I was very unhappy with the setup on my 350z BBK. The pads were quite noisy and would squeal quite a bit under partial braking. They are also extremely dusty!

On the track, they faded like it was their job! I found them to go mushy in only a few laps. They didn't last long, though that is forgivable.

Anyway, I was looking toward the HPS or HP+ pads, however on Specialtyz.com, I see them recommending the Brake-man pads.

Has anyone tried these, and can you rate them on:
-Noise
-Fade
-Dust
-Life

Also, if anyone else is running different pads, I'd like to hear your opinions on them.

Thanks!

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.