Subject	Yes, the car pulls to the low side. The right one.
Posted by	huey24nissan(NC) on April 28, 2009 at 7:22 PM
	This message has been viewed 52 times.
In Reply To	Re: you are getting some bad advice - listen to DEVILS Z.. posted by tognot on April 28, 2009 at 03:56 PM
Message	This is shown in my alignment specs I posted at the top. I do have less caster on the right, side it's pulling to and it's just slightly out of spec. It does it on a flat road yes, checked many times. I've replaced my brake pads, brake rotors and even the brake calipers in the front, thinking it was a dragging brake. Still the same problem. Best I can describe it is this...........if you hold the wheel straight it goes straight down the road. Let go of the wheel, it turns itself to the right just a tick, then the car goes right.
Follow Ups	What else can affect caster? - huey24nissan(NC) 10:13:07 04/28/09 Re: What else can affect caster? - jjpp2Z 10:35:14 04/28/09 Here is my most recent alignment......... - huey24nissan(NC) 10:47:08 04/28/09 Springs. I am pretty sure that ride height effects caster - MrPulldown 11:31:32 04/28/09 Negative - DEVILS Z-Tech (CA) 14:54:24 04/28/09 I don't think caster is his "problem" - Adam (NoVA) 16:23:07 04/28/09 whats the story on your shocks and springs (n/m) - Adam (NoVA) 11:36:32 04/28/09 Shocks are OEM adjustbales, replaced less than 2 years ago. - huey24nissan(NC) 12:06:49 04/28/09 Time for some springs. (n/m) - Woody75 (Denver) 12:18:38 04/28/09 OEM springs are on back order. - huey24nissan(NC) 12:25:57 04/28/09 I would get the Eibachs... - CameronSF 12:42:21 04/28/09 I can get all 4 OEM for $500 when they are in stock. (n/m) - huey24nissan(NC) 12:44:37 04/28/09 AKA Double the cost of Eibachs. (n/m) - BigTDogg (MA) 13:10:06 04/28/09 LoL. (n/m) - Bernie (NoVA) 16:26:43 04/28/09 Please don't laugh at me. - huey24nissan(NC) 19:32:39 04/28/09 I'm laughing @ the notion of spending $500 on OEM springs (n/m) - Bernie (NoVA) 21:18:54 04/28/09 When I went to the Eibachs from OEM springs, retaining - Cap927(Boston) 12:50:18 04/28/09 How is the ride with Eibachs ? - huey24nissan(NC) 13:03:04 04/28/09 I don't mind the ride, specially still having the option - Cap927(Boston) 13:24:17 04/28/09 Eibach pro-kit springs are .8" lower than "normal" oem - Inzane 18:00:58 04/28/09 200,000 miles on the stock springs. - Adam (NoVA) 15:45:11 04/28/09 I don't want adjustable parts. - huey24nissan(NC) 19:19:03 04/28/09 YGM (n/m) - Adam (NoVA) 20:05:17 04/28/09 Cross Caster can affect the pulling but... - DEVILS Z-Tech (CA) 13:12:04 04/28/09 Re: you are getting some bad advice - listen to DEVILS Z.. - tognot 15:56:15 04/28/09 replacing springs w/200k miles on them is bad advice? (n/m) - Adam (NoVA) 16:31:33 04/28/09 It could be if springs don't need replacing - DEVILS Z-Tech (CA) 18:38:20 04/28/09 I measured my ride height........... - huey24nissan(NC) 19:31:13 04/28/09 Yes, the car pulls to the low side. The right one. - huey24nissan(NC) 19:22:59 04/28/09 Are Adj. Tension arms really that bad? - Pilot.P (NZ) 18:12:42 04/28/09 There is definitely a difference felt - ZiNnYc 08:26:57 04/29/09 If your adjustable tension rods were installed incorrectly.. - DEVILS Z-Tech (CA) 18:52:05 04/28/09 The caster could cause it but with it being that little bit - Spddracer 20:23:48 04/28/09 I forgot to mention.. - DEVILS Z-Tech (CA) 23:00:18 04/28/09
Post a Followup	You cannot reply to this message because you are not logged in.