Subject	Most likely the front cross member.
Posted by	apudapus on April 28, 2009 at 2:14 PM
	This message has been viewed 71 times.
In Reply To	So I see they are using a two bar cart type thing to set the posted by wiZardZ on April 27, 2009 at 11:41 PM
Message	This method is not recommended because the following have to be removed: -steering rack -front cross member (maybe the hubs, and I guess the lower control arm, hmmm.....) -AC compressor and AC lines (bad because you have to drain and refill, hopefully you have this done at a shop to save our environment) -power steering pump and lines (you might be able to just push these out of the way but hardly worth the effort) *********************************
Follow Ups	Pulling motor with 2-post lift - wiZardZ 21:28:38 04/27/09 this video? - J-Mart 22:12:43 04/27/09 Thats the wrong link but yeah I think it was MSP. It was the - wiZardZ 22:40:54 04/27/09 You sure it wasn't MWS? - Evan(CA) 22:54:23 04/27/09 Yeah that was it. Thanks (n/m) - wiZardZ 22:55:42 04/27/09 So I see they are using a two bar cart type thing to set the - wiZardZ 23:41:50 04/27/09 Most likely the front cross member. - apudapus 14:14:24 04/28/09
Post a Followup	You cannot reply to this message because you are not logged in.