Subject	Pulling motor with 2-post lift
Posted by	wiZardZ on April 27, 2009 at 9:28 PM
	This message has been viewed 112 times.
Message	So here in the near future I am going to be pulling my motor to replace my turbos and I am wondering if anyone has used a car lift to take out the motor? I saw it done once in an na->tt swap video but I don't remember where the video went. What I want to do is undo all the top stuff like wiring harness and such and then lift the car off of the engine and transmission instead of pulling the motor out the top. Anyone have any instructions to follow or tips? Thanks ---Sig---
Follow Ups	Pulling motor with 2-post lift - wiZardZ 21:28:38 04/27/09 this video? - J-Mart 22:12:43 04/27/09 Thats the wrong link but yeah I think it was MSP. It was the - wiZardZ 22:40:54 04/27/09 You sure it wasn't MWS? - Evan(CA) 22:54:23 04/27/09 Yeah that was it. Thanks (n/m) - wiZardZ 22:55:42 04/27/09 So I see they are using a two bar cart type thing to set the - wiZardZ 23:41:50 04/27/09 Most likely the front cross member. - apudapus 14:14:24 04/28/09
Post a Followup	You cannot reply to this message because you are not logged in.