Subject	Camber suggestions...
Posted by	ZiNnYc on April 27, 2009 at 4:43 PM
	This message has been viewed 292 times.
Message	what camber are you guys satisfied with? Past two days I have been playing with -4 degrees in the rear and -2 degrees in the front (immediately post CO install), and my cornering was absolutely phenomenal. Per Dr. Kuahs suggestions for a street setup that is a compromise between tire wear and cornering capability, my alignment guy set the camber to -2 up front and -1.5 in the rear. (Stock caster, 1/16" toe in). Took some twisties, and my cornering has drastically decreased to the point in which I'm not happy. My test area is a dead end alley...yesterday was able to take the sharp right and sharp left (90 degree turn) at 50 mph without any tire screech, now I can only duplicate that at 30. I was wondering if anyone has found a happy medium with more camber without the downside of the tire wear i.e. any good experiences with -2.0, -2.5, etc? ********
Follow Ups	Camber suggestions... - ZiNnYc 16:43:27 04/27/09 -2 F, -4 R is way too negative for a "street" alignment IMHO - Inzane 16:49:29 04/27/09 I wont be a track whore - ZiNnYc 16:51:49 04/27/09 Re: I wont be a track whore - ouikikazz 17:00:27 04/27/09 Way too much suspension for a DD, IMO... - BradZ (UF) 14:09:18 04/28/09 Hi hater! (n/m) - ZiNnYc 15:50:26 04/28/09 2nd on all accounts - zgene4 17:16:39 04/27/09 Keep it at fact setings and re adj for the track! (n/m) - Emxracer (SOCAL) 17:06:45 04/27/09 Perhaps some are misunderstanding me... - ZiNnYc 17:11:46 04/27/09 Why couldn't you do stock specs and be happy? - LJZTT 17:19:20 04/27/09 There is no way in hell - ZiNnYc 20:09:30 04/27/09 these aren't sentras, I watched a pro run rings around - LJZTT 22:19:22 04/27/09 You're right. What was i thinking? - ZiNnYc 22:25:53 04/27/09 Why do you need adjustable A-arms for a NYC DD?? - LJZTT 22:39:01 04/27/09 You didnt read my OP then. (n/m) - ZiNnYc 22:40:30 04/27/09 your test area is a dead end alley, enough said - LJZTT 22:44:53 04/27/09 my bad, had I read your profile I wouldn't have wasted - LJZTT 22:48:13 04/27/09 First stock camber, now moderate camber. - ZiNnYc 22:51:31 04/27/09 nothing has changed, get a better tire/wheel combo first - LJZTT 22:57:25 04/27/09 Free Advice: Throgs Neck Br & take Cross Isl Pkwy exit - Nick(CT) 18:01:31 04/27/09 been there, done that :) - ZiNnYc 20:07:35 04/27/09 Try the helix exiting the Lincoln Tunnel to 495 (n/m) - Needraggr 20:24:50 04/27/09 cruise to all these spots? (n/m) - Justin (Staten Island, NY) 20:34:00 04/27/09 I dont think the NJ approach to the Lincoln Tunnel is a - Gordo 93TT Daytona 21:04:22 04/27/09 Exiting is more exciting. - Needraggr 22:29:55 04/27/09 I ran -2.4 front and rear for quite a while, and while - Guapo 17:21:36 04/27/09 As far as tire wear goes, you shouldn't see unreasonably - TriniTT 18:01:00 04/27/09 At -4, you are going to see uneven inside wear!! (n/m) - MrPulldown 18:41:36 04/27/09 are you kidding me? - AntiHero 23:04:07 04/27/09 False. (n/m) - Bernie (NoVA) 01:01:14 04/28/09 -1.6 rear and -2.5 front with 0 toe fr/rr. - Scotts94z32 18:04:31 04/27/09 close enough :) (n/m) - Guapo 19:08:37 04/27/09 yay 4 facepalm. (n/m) - Halo Z 19:57:58 04/27/09 Best EVER for street; -.8 front -.5 rear (n/m) - ni[X]it 20:18:58 04/27/09 How about +.1 rear for NOS-based launches for alley drags? (n/m) - Scotts94z32 11:02:07 04/28/09 Keep in mind wet traction - Ashman2k2 20:25:13 04/27/09
Post a Followup	You cannot reply to this message because you are not logged in.