| Progress Post #1 Progress Post #2
I have been putting off ordering my ever growing list of parts needed to finish the Z for far too long. I finally said screw it knowing that no matter how long I wait most likely something else will come up and I will have to just keep waiting.
A little bit of fun stuff from Powertrix but mostly maintenance. (Camber kit from Z1)
 My first big purchase from Z1. No complaints.
 I think I ordered just about every single silicon hose they offer with the exception of the pcv stuff. The rubber hoses throughout my engine bay were brittle. They pretty much crumbled as I removed them. Hopefully these new hoses will aid in reliability and peace of mind. 
No she didn't come from Z1.
It's been pretty hot here in California this last week so I have not made too much progress. I got a bunch of stuff partially finished just to find out I needed some gasket or hose before I could finish. It's frustrating to see so many half finished projects.
For example. I got my injectors installed in the fuel rail with the DW adaptors but of course I didn't realize there were o-rings between the rail and the lower plenum. I removed the oil pan to reseal it just to find out I needed a front and rear gasket...might as well get the rear main and retainer gasket well your there. Oh, and to remove the oil pan you have to loosen the oil filter bracket...there's another gasket to replace. Then I went to reseal all of the valve covers. I got them all done except for the driver's side exhaust cover. Seems like it would be way easier to replace the pcv hose on it at the same time of resealing it...and of course I didn't have any of those hoses yet. I could go on and on. I have learned alot along the way, that's for sure. 
EFI harness replaced with '95.
 
EBC wired and temporally installed here.
 ECU eeprom soon to be replaced with Ztuner eeprom. (Was Ashspec)
 My Wife thought it was funny the first time she came into the garage and saw me standing where the engine normally goes. She just had to take a picture. I dont see whats so funny.
 I also got my Z1 ic's installed. They were surprisingly tough to install. Well, the first one was. I suppose I just needed a little practice because the second one went on much easier.
Formerly: Evan3zx(ca)
Xbox live GT: kidding Me 1991 CRP TT
1993 Pearl White NA |
More parts...im getting soo anxious now. Progress post # 3 - 
