| Message |
You are correewct about needing a good sized part to get tensile strength tested. For a part I am making currently, to test the tensile strength of it, I had to supply the Texas based company with a piece of teh material no less than 6" long and 1/2" in diamtera. This includes the material needed for machining and clamping. You can't get a piece that large from the crankshaft.
Thanks,
Mike
1991 Black 3.0 Twin Turbo La-Z-Link
^^Hard engine break in method^^
La-Z-Link
^^MY FACEBOOK...CHECK IT OUT^^ 
---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that.
"felt wierd fingering my exhuast for 1hr with no results :(" - zboost
"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21 |
 |
