Subject	Although im not sure 6' will make it all the way
Posted by	blackomega on April 21, 2009 at 2:45 PM
	This message has been viewed 31 times.
In Reply To	it depends on where you mount the gauge I suppose. posted by The Devils Z on April 21, 2009 at 02:29 PM
Message	to the driver A pillar? Looking at your slideshow it looks a few inches short, is that safe to say? Any similar entrance to the cabin from the drivers side wheel well? I think SZ will mount the o2 bung on either test pipe LH or RH if you ask them but dont quote me on that.
Follow Ups	Where do I route AEM wideband from the SZ 3" testpipes - blackomega 11:55:12 04/21/09 Re: Where do I route AEM wideband from the SZ 3" testpipes - ouikikazz 12:17:33 04/21/09 thanks for your input (n/m) - blackomega 12:30:40 04/21/09 I am starting to assume - blackomega 14:04:34 04/21/09 it depends on where you mount the gauge I suppose. - The Devils Z 14:29:06 04/21/09 shooting for the A pillar - blackomega 14:39:00 04/21/09 Although im not sure 6' will make it all the way - blackomega 14:45:12 04/21/09 how long is the cable? (n/m) - Atl300zxTT 14:31:45 04/21/09 6 Feet (n/m) - blackomega 14:38:19 04/21/09 You can drill a hole in the floor board in the tranny hump. - Yoshi 16:25:22 04/21/09 That really would be most direct. - blackomega 16:30:33 04/21/09 And it works very well. It's also easier to avoid the - Yoshi 09:30:39 04/22/09 Where exactly in the tranny hump do i drill?> - blackomega 19:05:12 04/22/09 Passenger fender has an opening to the interior - BigTDogg (MA) 17:00:37 04/21/09 Re: Where do I route AEM wideband from the SZ 3" testpipes - TTFairladyZ 17:52:18 04/21/09 You drilled thru the floorboard from the tranny hump? (n/m) - blackomega 19:07:40 04/21/09 No drilling, just slide the harness through (n/m) - TTFairladyZ 19:35:45 04/21/09 hard to do with the tranny in? - blackomega 20:09:56 04/21/09 Not all all. Shoot me an email if you have any other q's (n/m) - TTFairladyZ 21:46:43 04/21/09 Re: Re: Where do I route AEM wideband from the SZ 3" testpipes - ConVerTT 22:30:44 04/22/09
Post a Followup	You cannot reply to this message because you are not logged in.