Subject	I am starting to assume
Posted by	blackomega on April 21, 2009 at 2:04 PM
	This message has been viewed 40 times.
In Reply To	Where do I route AEM wideband from the SZ 3" testpipes posted by blackomega on April 21, 2009 at 11:55 AM
Message	That you run it through the passenger wheel well to the firewall, but that seems like an area at risk of debris or something damaging the cable?
Follow Ups	Where do I route AEM wideband from the SZ 3" testpipes - blackomega 11:55:12 04/21/09 Re: Where do I route AEM wideband from the SZ 3" testpipes - ouikikazz 12:17:33 04/21/09 thanks for your input (n/m) - blackomega 12:30:40 04/21/09 I am starting to assume - blackomega 14:04:34 04/21/09 it depends on where you mount the gauge I suppose. - The Devils Z 14:29:06 04/21/09 shooting for the A pillar - blackomega 14:39:00 04/21/09 Although im not sure 6' will make it all the way - blackomega 14:45:12 04/21/09 how long is the cable? (n/m) - Atl300zxTT 14:31:45 04/21/09 6 Feet (n/m) - blackomega 14:38:19 04/21/09 You can drill a hole in the floor board in the tranny hump. - Yoshi 16:25:22 04/21/09 That really would be most direct. - blackomega 16:30:33 04/21/09 And it works very well. It's also easier to avoid the - Yoshi 09:30:39 04/22/09 Where exactly in the tranny hump do i drill?> - blackomega 19:05:12 04/22/09 Passenger fender has an opening to the interior - BigTDogg (MA) 17:00:37 04/21/09 Re: Where do I route AEM wideband from the SZ 3" testpipes - TTFairladyZ 17:52:18 04/21/09 You drilled thru the floorboard from the tranny hump? (n/m) - blackomega 19:07:40 04/21/09 No drilling, just slide the harness through (n/m) - TTFairladyZ 19:35:45 04/21/09 hard to do with the tranny in? - blackomega 20:09:56 04/21/09 Not all all. Shoot me an email if you have any other q's (n/m) - TTFairladyZ 21:46:43 04/21/09 Re: Re: Where do I route AEM wideband from the SZ 3" testpipes - ConVerTT 22:30:44 04/22/09
Post a Followup	You cannot reply to this message because you are not logged in.