TwinTurbo.NET: Nissan 300ZX forum - Looks good, few suggestions
People Seeking Info
 
   


     
Subject Looks good, few suggestions
     
Posted by BigTDogg (MA) on April 21, 2009 at 9:54 AM
  This message has been viewed 153 times.
     
In Reply To My engine pull/swap posted by jb.michael on April 21, 2009 at 09:32 AM
     
Message 1) I'd get the MSP manifolds, much higher quality than the AMS garbage. Specialty Z or Import Parts Pro can help you out.

2) Same with the pulley combo, Import Parts Pro can get you a good deal on an ASP pulley and water pump pulley.

3) How much are the Megan coilovers? If they're anywhere close to these, I'd highly recommend them over the Meagans

4) Nice choice on the clutch. I have one and it's a work of art. Contact member Spddracer to buy; Joe is great to deal with.

5) What turbos are you planning on running? I wouldn't get 850's unless you have a monster build. Be sure to get the 300° rails from an approved vendor though, see the sticky above.

Good luck with the build, it's definitely fun :-)





"...Downpipes own. They own everything...anything...all there ever was and will be...they should be stock on all cars. Screw the environment, emissions, noise! I love them...I shall name my first-born after them with glee..." - SeedyRom 05:13:20 10/03/02

"i love the cock" - genic 22:20:47 09/25/03

"I hope you get fucked in the ass with a pringles can." - ni[X]it 14:53:53 02/02/06

"Either ignore him or beat him up. Anything else will be over his head." - Marshall 12:28:23 08/18/04

"Ok, Ill bite.." eriksu9 15:42:10 04/04/08

z32baby: yeah, my memory sucks balls
DJ Juiced: What's your memory doing this friday night? ;)

"i've got to the point where i can drive the Z at its limits and i want more" - shadowZ 16:29:56 08/31/04

"I was way more timid then than I am now about getting in there and yanking on things." - TT XTZ 13:30:34 07/25/05

"Just ran out to get some knee pads. I'm ready now... BRING.....IT.....ON... :-) " - Dave N 19:04:30 10/31/07

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.