Subject	Fuel pump kill switch
Posted by	inf on April 17, 2009 at 4:21 AM
	This message has been viewed 192 times.
Message	So I made my kill switch, but my car isn't idling as well. It's also more difficult to start up. I used 18 gauge wire, but I soldered the wires onto the switch which slightly melted the unit. It still works and everything, but I'm just wondering if the hesitation is caused by it?
Follow Ups	Fuel pump kill switch - inf 04:21:28 04/17/09 *which slightly melted the unit* - robo (sebring1970) 04:32:05 04/17/09 What method did you use? (n/m) - KevinZtwin 10:21:04 04/17/09 The wrong one. (n/m) - Bernie (NoVA) 10:42:54 04/17/09 you here all week? (n/m) - chicagozer 12:26:42 04/17/09 Tip your waiter, try the veal. (n/m) - Bernie (NoVA) 12:57:56 04/17/09 lol, if you were any drier you'd need an IV. good stuff. (n/m) - robo (sebring1970) 14:16:16 04/17/09 which one was that? (n/m) - inf 14:20:27 04/17/09 Just bypass the switch and see if that clears the issue. (n/m) - ZEVAN (Ca) 11:48:16 04/17/09 He might have cooked his relay though. (n/m) - MrPulldown 13:03:01 04/17/09 nah nm, my car never idled well, so it doesn't matter - inf 14:18:58 04/17/09 Re: nah nm, my car never idled well, so it doesn't matter - ouikikazz 16:08:35 04/17/09 cry a river (n/m) - inf 16:29:43 04/17/09 What's your attitude about? - Bernie (NoVA) 23:49:32 04/17/09
Post a Followup	You cannot reply to this message because you are not logged in.