Subject	nissan
Posted by	nissansx on April 14, 2009 at 10:04 PM
	This message has been viewed 211 times.
In Reply To	czp posted by cossiemodo2000 on April 14, 2009 at 09:55 PM
Message	95 rails with a correctly machined lower plenum works great, just takes a bit more work. and make sure to get the spacers from yugobernie. otherwise get 300degree rails from Specialty Z or ImportPartPro.
Follow Ups	czp - cossiemodo2000 21:55:12 04/14/09 keep reading, 2nd page would be a good place to start. (n/m) - zgene4 21:57:44 04/14/09 nissan - nissansx 22:04:05 04/14/09 *slaps head* (n/m) - SuparexTT 22:11:28 04/14/09 if you have nothing usefull to add just keep your comments - cossiemodo2000 22:45:11 04/14/09 *slaps head* (n/m) - SuparexTT 22:46:50 04/14/09 LOL (n/m) - CameronSF 23:14:44 04/14/09 haahahahah your head should be hurting by now (n/m) - cossiemodo2000 23:18:47 04/14/09 Re: czp - cossiemodo2000 22:29:03 04/14/09 If you install the 300 Degree rails properly they will not - Seb@Specialty-Z 00:51:11 04/15/09 2nd Seb's comment. Haven't had an issue yet. Thanks SZ! (n/m) - Twindragon 11:39:29 04/15/09 "he has been always very helpful and honest in the past" ?? - yobobrox 07:56:27 04/15/09 Kyle @ IPP, SPLParts & Specialty Z are in the clear. (n/m) - Bernie (NoVA) 23:57:54 04/14/09 Copy & paste is your friend.... :-) (n/m) - MeatMan 20:19:04 04/15/09 yeah i just got home from work - Alan(MD/NJ) 01:07:43 04/15/09 your setup did not have the cut for the oring - spyhunterTT(nj) 15:34:25 04/15/09 phewwww! - Alan(MD/NJ) 18:47:00 04/15/09 If he doesn't know when he started making them, - 952+2TT 19:25:35 04/15/09 yeah it was rather upsetting speaking to him - Alan(MD/NJ) 22:12:00 04/15/09 Sounds like he's pleading the fifth. (n/m) - Dave N 22:46:36 04/15/09
Post a Followup	You cannot reply to this message because you are not logged in.