TwinTurbo.NET: Nissan 300ZX forum - Fender rolling and carbon fibre
People Seeking Info
 
   


     
Subject Fender rolling and carbon fibre
     
Posted by Invader on April 08, 2009 at 5:06 PM
  This message has been viewed 864 times.
     
     
Message Got my car back from the body shop today.

Had the rear fenders rolled because my new tires aren't as stretched as the previous set (Nankang vs Toyo)

Anyway, when i got the Nankangs mounted the rears stuck out a lot and rubbed when i drove over a dip in the road at over 80km/h.

You can see in the pics the aftermath of rubbing.

I also got the Ionic dynamics carbon fibre door pillar cover put on. Not pictured is my KingZ vented panel, i'm getting that put on tomorrow.
The last pic i think is the front, how many inches should i lower it to tuck my wheel in?
Here are the pics in no particular order:

IMG_2826.jpg

IMG_2827.jpg

IMG_2830.jpg

IMG_2831.jpg

IMG_2832.jpg

IMG_2835.jpg

IMG_2833.jpg

IMG_2836.jpg

Photobucket

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.