Subject	Repair succeeded
Posted by	Jehannum on March 25, 2009 at 6:01 PM
	This message has been viewed 67 times.
In Reply To	Well good luck with the repairs :) (n/m) posted by Guapo on March 24, 2009 at 11:36 AM
Message	It turned out I just needed to hit the socket with a little tech spray, though I cleaned up the solder joints because I was down at the solder station, and they looked horrible. Resistance went from 8 ohms to 0.3 ohms. Note to Coz: hire somebody else to do your socketing! Now, does anyone know how to solder a replacement Vcc pin onto a 27c256 chip? Your powers are useless! I'm wearing my tinfoil underwear!
Follow Ups	How many layers is the ECU PCB? - Jehannum 11:23:29 03/24/09 Nissan called Jecs and said "yo print these bad boys" (n/m) - Bernie (NoVA) 11:25:59 03/24/09 You broke traces while trying to install a chip - Guapo 11:29:10 03/24/09 Yes. - Jehannum 11:32:52 03/24/09 Well good luck with the repairs :) (n/m) - Guapo 11:36:32 03/24/09 On the ECU or the altar boy? (n/m) - Z_Cherub 12:34:38 03/24/09 the ECU obviously, the altar boy can't be repaired. (n/m) - Cap927(Boston) 12:40:51 03/24/09 Repair succeeded - Jehannum 18:01:34 03/25/09 im pretty sure they are at least 3 layer - Halo Z 13:11:48 03/24/09 Thanks - Jehannum 13:14:45 03/24/09 unless you ripped out the cup, you should be fine. (n/m) - Halo Z 15:23:28 03/24/09
Post a Followup	You cannot reply to this message because you are not logged in.