Subject	Correct. The "groove" on the ring gear is facing the starter
Posted by	91Z32TT on March 17, 2009 at 2:10 AM
	This message has been viewed 68 times.
In Reply To	thinking clutchmasters installed the ring gear backwards (n/m) posted by gt300zxtt on March 17, 2009 at 01:31 AM
Message	when it should be on the back, facing the motor. This is causing the starter to have difficulty grabbing onto the flywheel. Your issue may just be a bad starter or worn ring gear, that's what had happened on my old RPS flywheel. (Bad starter that led to bad ring gear)
Follow Ups	Hmm.. think this might be the problem? - 91Z32TT 20:08:39 03/16/09 that's one small clutch (n/m) - spyhunterTT(nj) 20:17:18 03/16/09 Yeppers, the ring gear is backwards. - LitlElvis 20:52:58 03/16/09 For a twin, it was fairly inexpensive @ $1300, flywheel - 91Z32TT 21:45:09 03/16/09 Glad you found the problem! (n/m) - ThunderZ 22:27:42 03/16/09 Me too! Thanks for taking a stab at the fix! (n/m) - 91Z32TT 22:32:31 03/16/09 dang (n/m) - aliaZ 22:36:52 03/16/09 Wow that's a tiny clutch assembly! (n/m) - collegeboy 23:21:40 03/16/09 Whole assembly w/flywheel weighs less than my RPS clutch :) (n/m) - 91Z32TT 00:40:56 03/17/09 Because it's using multi-disk, no need for large diameter. (n/m) - sparkie 10:37:04 03/17/09 I have the same prob but dont get what your talking about - Nis300owner 01:00:37 03/17/09 thinking clutchmasters installed the ring gear backwards (n/m) - gt300zxtt 01:31:49 03/17/09 Correct. The "groove" on the ring gear is facing the starter - 91Z32TT 02:10:54 03/17/09 Re: Correct. The "groove" on the ring gear is facing the starter - WazTTed 08:28:31 03/17/09
Post a Followup	You cannot reply to this message because you are not logged in.