Subject	Re: Does this look like epoxy on my drivers side water jacket
Posted by	zxautogiro on March 08, 2009 at 1:53 PM
	This message has been viewed 72 times.
In Reply To	Does this look like epoxy on my drivers side water jacket posted by 300NASeattle on March 08, 2009 at 12:35 PM
Message	yeah but no problem on it if no leaks, its just at plug to close the drain cooling
Follow Ups	120k Done! Look Ma - no smoke. - 300NASeattle 11:44:46 03/08/09 Good job. (n/m) - SWhiteTT(WA) 11:54:51 03/08/09 Does this look like epoxy on my drivers side water jacket - 300NASeattle 12:35:22 03/08/09 yeah looks like it (n/m) - Seb (specialty-Z) 12:41:39 03/08/09 I won't be fully draining engine jacket then. (n/m) - 300NASeattle 12:47:10 03/08/09 Re: Does this look like epoxy on my drivers side water jacket - zxautogiro 13:53:17 03/08/09 PTU is fine where it is. HI pulley still lacking. (n/m) - Bernie (NoVA) 13:21:51 03/08/09 2nd. I would leave the PTU there. I've had no problems - davidztt 17:40:50 03/08/09 Is relocation a good idea in general? - kenecchi 19:10:34 03/08/09 The whole point behind relocating the PTU was to extend - Bernie (NoVA) 20:04:51 03/08/09 nice job! Should have used the jap. sticker! (n/m) - nemo1080 (Iowa) 14:29:12 03/08/09 Re: 120k Done! Look Ma - no smoke. (n/m) - opus300zx 17:42:20 03/08/09 Congrats. Thanks for the sticker reminder. - rojoloco (San Diego) 02:26:47 03/09/09
Post a Followup	You cannot reply to this message because you are not logged in.