Subject	Yup, 93+ were cast iron. (n/m)
Posted by	BigTDogg (MA) on March 08, 2009 at 12:14 PM
	This message has been viewed 94 times.
In Reply To	Actually, the 90NA had the smaller caliper, but was the same posted by Guapo on March 08, 2009 at 11:51 AM
Message
Follow Ups	Brake Calipers - Dave07 11:19:36 03/08/09 non turbo is perfectly fine for the rears. (n/m) - ni[X]it 11:39:47 03/08/09 and the front, as long as it's not coming from a 1990NA (n/m) - Guapo 11:45:42 03/08/09 correct, front steel calipers versus aluminum calipers... - ni[X]it 11:48:49 03/08/09 Actually, the 90NA had the smaller caliper, but was the same - Guapo 11:51:59 03/08/09 Yup, 93+ were cast iron. (n/m) - BigTDogg (MA) 12:14:59 03/08/09 My 91 built in 10/90 had the 26mm calipers :( (n/m) - en5 15:36:33 03/08/09 Sounds to me like you nead a seal kit. (n/m) - Bernie (NoVA) 13:28:26 03/08/09 the last time I tried sourcing new seals for the rears, - ni[X]it 13:38:44 03/08/09 Aftermarket: - 96300NAZ 14:13:54 03/08/09 Any thoughts on the Centric kit Coz sells? - John B. (NJ) 14:14:38 03/08/09 I bought that kit, along with the front set - BigTDogg (MA) 15:14:38 03/08/09 yeah. pull them apart first and tale them to the PCer, - Halo Z 16:32:15 03/08/09 If i were powder coating... - John B. (NJ) 17:17:26 03/08/09 Yeah, I was going to follow the FAQ. (n/m) - BigTDogg (MA) 10:24:20 03/09/09 =( i have 3 sets i would like to rebuild. (n/m) - Halo Z 14:53:14 03/08/09 What is it about the current rear calipers that make you - davidztt 17:55:31 03/08/09
Post a Followup	You cannot reply to this message because you are not logged in.