| the shop that installed them deals only with custom suspensions. i suppose anything is possible though. the owner was aligning and corner balancing my car when evan came into discuss the install of his parts. i installed the parts on mine and brought it to them. even at that the owner went over that point when we went over dialing out preload on the sway bars should i adjust them. they were well aware of pillowball install error. im aware that you need to run tension rods, if you run the front upper arms. does it go both ways? would excessive play in the bushings of the factory upper arms cause the tension rods to exhibit this behavior? honestly i just dont see those bearings failing that quickly without complete incompetence on the install, or other worn parts causing the wear.
|
