| Message |
some type of funnel or scoop at the front end to collect the air. The frontal surface area of the tubing alone won't capture much air. BUT, it was easy, didn't cost you much, and won't hurt. And just to pass along what I've been gathering information wise on a similar project, you want to direct the air to the center of the rotor, ideally, and not to the rotor face. That way the cooler air passes through the cooling vanes of the rotor and has an effect on the entire rotor vs just the inside face which does nothing for your outboard pad temps. It would be nice of someone made a cooling kit that bolts to our wheel knuckle like they make for various other platforms.
"Too dumb for opera, too smart for NASCAR." |
 |
