TwinTurbo.NET: Nissan 300ZX forum - Didnt pull it the last time either. Did it with the block in (n/m)
Subject
Didnt pull it the last time either. Did it with the block in (n/m)
Posted by
LivinTheDream
on February 10, 2009 at 7:49 AM
This message has been viewed
169
times.
In Reply To
nice, did you rip it down without pulling it this time?
posted by nemo1080 (Iowa)
on February 09, 2009 at 11:38 PM
Message
Follow Ups
Tractor bolt guy. Got her down in a day. Horror pics
-
LivinTheDream
23:31:02 02/09/09
Oh by the way I relised that the tension pulley didnt expand
-
LivinTheDream
23:35:46 02/09/09
There should be about a 4mm gap in the tensioner and the
-
5280Z_nightstalker
23:46:21 02/09/09
Did it stay at 4mm once it was turned over a few times?
-
Woody75 (Denver)
08:07:59 02/10/09
NO. This is very poor advice. If you need to nudge
-
Guapo
08:45:27 02/10/09
Yes it worked fine for me. Whenever I set mine to 4mm and
-
5280Z_nightstalker
10:31:28 02/10/09
Glad it worked for you. It is still not the right way
-
Guapo
10:34:56 02/10/09
Please don't give advice like this - it's not a smart way to
-
Bernie (NoVA)
11:09:44 02/10/09
nice, did you rip it down without pulling it this time?
-
nemo1080 (Iowa)
23:38:21 02/09/09
Didnt pull it the last time either. Did it with the block in (n/m) -
LivinTheDream
07:49:25 02/10/09
replace with an ati crank pulley (n/m)
-
collegeboy
00:20:33 02/10/09
I bet he could find a zillion used stock pulleys for cheap
-
LitlElvis
06:41:31 02/10/09
hmm... (n/m)
-
550HPTT
07:03:43 02/10/09
I have 2 clean stock pulleys that are correct for your car
-
Bernie (NoVA)
08:16:48 02/10/09
Get a new pulley..
-
Drk93TT
08:56:43 02/10/09
Get a ASP UD pulley from IPP. (n/m)
-
Woody75 (Denver)
09:11:55 02/10/09
2nd. (n/m)
-
JustinSCZ32
10:05:43 02/10/09
Post a
Followup
You cannot reply to this message because you are not
logged in
.