Subject	Brake Duct Guide
Posted by	mvtz on January 27, 2009 at 7:40 PM
	This message has been viewed 197 times.
Message	I remember a while back where there was a guide on how to make brake ducts using a the upper water pipes or someting of the sort. They were attached to the back of the rotor to feed cold air into the center. Im am unable to find the thread and was looking for some help. Thanks
Follow Ups	Brake Duct Guide - mvtz 19:40:49 01/27/09 I only know fo the ones attached to the tension rod (n/m) - MrPulldown 20:18:21 01/27/09 I <3 bookmarks - ZLover4Life 21:24:57 01/27/09 side note: holy crap it doesn't feel like almost 7 years ago (n/m) - ZLover4Life 21:26:33 01/27/09 damn.. 7 years! - KongZTT GT28RS MD 21:32:25 01/27/09 nice! (n/m) - nemo1080 (Iowa) 22:31:51 01/27/09 Go on ebay or similar.. and buy the hose ducting.. - KongZTT GT28RS MD 21:27:54 01/27/09 Nope, not that one... - mvtz 21:58:06 01/27/09 ... I'd bet Nixit's works better... (n/m) - ZLover4Life 22:09:21 01/27/09 Or the OEM ones or SPL's guides for their t-rods (n/m) - BigTDogg (MA) 15:18:30 01/28/09 not sure about the OEM ones... they seem kinda small - ZLover4Life 19:52:20 01/28/09 Here's a good one as well - TTFairladyZ 22:32:45 01/27/09 lovin the rear brake cooler mod. way cool. (n/m) - nemo1080 (Iowa) 22:39:40 01/27/09 That just seems too sloppy. - ZiNnYc 16:46:29 01/28/09 found it or pretty close to it - mvtz 17:37:39 01/29/09
Post a Followup	You cannot reply to this message because you are not logged in.