| - Good sized breaker bar for the crank bolt? - Electrical plastic conduit coupler for setting the seals (Home Depot has them)? I have the part in the garage - can give you the exact specs if you don't already have it? - Dremel tool and small wire brush head. Fast way to remove gasket maker from the thermostat cover fitting. - Red and Blue loctite - Stud puller: But if you don't have one >>> There's another way to get them out using the loctite. Undo the nut and remove the pulley wheel. Re-install the nut using RED loctite and let it set up. Once hardened that nut will be chemically welded to the stud. Use a socket or wrench to unscrew the stud - studs aren't in the block that tight.
- Rubber faced mallet is fine
|
