Subject	You can make your own for under $5.00 with..
Posted by	MikeH(Phoenix) on June 16, 2001 at 7:08 PM
	This message has been viewed 34 times.
In Reply To	Are 300 Degree EGR Blockoff Kits Available? posted by MIT-Z on June 16, 2001 at 06:49 PM
Message	two pennies and JB weld. That is what I did and the hold really good. Use the pennies to block off the port and JB weld epoxy to seal it. Arizona'a most powerful 600HP 15 second Z More powerful than a stock TT , slower than an NA Dynoed 515 rwhp and 420 ft.lbs @ 16psi 89 degrees. 533 rwhp and 450 ft. lbs @19 psi and slipping clutch and heat soaked motor , 85 degrees.
Follow Ups	Are 300 Degree EGR Blockoff Kits Available? - MIT-Z 18:49:54 06/16/01 You can make your own for under $5.00 with.. - MikeH(Phoenix) 19:08:38 06/16/01 Ditto....did the same thing (n/m) - wesman [92TT-less ] 19:11:37 06/16/01 How did you block off the exhaust manifold port? (n/m) - MIT-Z 19:53:44 06/16/01 Use a pipe plug (n/m) - MikeH(Phoenix) 20:58:23 06/16/01 Yup, did the same thing here. (n/m) - safZ 21:07:51 06/16/01
Post a Followup	You cannot reply to this message because you are not logged in.