Subject	Always wanted to put those on with a rpm window switch...
Posted by	ttzcadet on December 31, 2008 at 12:06 AM
	This message has been viewed 115 times.
In Reply To	Time to make some noise with these Cutouts :) posted by jmurcybizd on December 30, 2008 at 10:16 PM
Message	Then you could keep them closed to spool up and open them up on the top end for better flow- not sure of the response time on the actuators though. It would be interesting to dyno them one chart with the open, one chart closed, plot the intersection and then use that for the rpm switch. Best of both worlds maybe?
Follow Ups	Time to make some noise with these Cutouts :) - jmurcybizd 22:16:11 12/30/08 Aghhh... Should have saved for the 3" catback (n/m) - 550HPTT 22:25:41 12/30/08 i already have the 3 inch test pipe coned down to 2 1/2 - jmurcybizd 22:55:22 12/30/08 shameless plug - volcomstone550 01:56:05 12/31/08 sorry :) (n/m) - jmurcybizd 02:26:04 12/31/08 Tell us how it goes, and a sound clip (n/m) - MK 300 23:22:58 12/30/08 definitely ill post the link later tomorrow :) (n/m) - jmurcybizd 00:35:59 12/31/08 Nice, where would they get welded on the TP's or after - Nostype2 23:23:21 12/30/08 On the test pipes, right before it cones down to 2 1/2 (n/m) - jmurcybizd 23:29:55 12/30/08 Nice, im sure it will sound great. (n/m) - Nostype2 23:38:53 12/30/08 Always wanted to put those on with a rpm window switch... - ttzcadet 00:06:13 12/31/08 that sounds like a good idea!! Now you got me thinking :) - jmurcybizd 00:35:17 12/31/08 There are much cheaper alternatives for that.... - zboost(NoVA) 01:43:16 12/31/08 i got them from summit racing for 350$ - jmurcybizd 01:48:29 12/31/08 backpressure hurts spool. (n/m) - AntiHero 11:00:17 12/31/08 yep (n/m) - aliaZ 12:19:17 12/31/08 2nd. (n/m) - turtleboy 19:01:43 12/31/08 I tried that, not much to be gained... - icsamerica 14:44:35 12/31/08
Post a Followup	You cannot reply to this message because you are not logged in.