Subject	You're correct.
Posted by	PiotrC70 on December 20, 2008 at 7:29 PM
	This message has been viewed 101 times.
In Reply To	thought I saw a post here the other day, where Seb posted by BannonZ on December 20, 2008 at 07:01 PM
Message	I started the post and SZ will no longer be carrying the gears once their stock is sold. Link to my original post Mark Leader stated they will still be made as a special order item. Someone also posted that a company out of Canada will still be carrying them. Ztune.ca
Follow Ups	Differential removed and ready for Leader Gears. - PiotrC70 12:39:29 12/20/08 I've found reinstalling the trans is the worst part. - en5 16:53:09 12/20/08 Using bolts with heads cut off as guides helps... - gunghoe9 17:00:36 12/20/08 timing belt idler studs also work well as guide pins (n/m) - aliaZ 18:05:10 12/20/08 Do it few times and it becomes easy :) (n/m) - Piranha(AZ) 17:18:42 12/20/08 No kidding! Pirahna witnessed my pattented 92 minute trans - nemo1080 (Iowa) 18:32:21 12/20/08 I thought they were discontinued? - BannonZ 18:32:47 12/20/08 they're not discontinued per Mark Leader (n/m) - aliaZ 18:46:53 12/20/08 just through SZ? (n/m) - BannonZ 18:48:31 12/20/08 SZ is the sole distributor - aliaZ 18:53:19 12/20/08 thought I saw a post here the other day, where Seb - BannonZ 19:01:27 12/20/08 Mark Leader responded to that same post (n/m) - aliaZ 19:27:16 12/20/08 You're correct. - PiotrC70 19:29:47 12/20/08 no - aliaZ 19:39:28 12/20/08 I could be misreading Marks reply as well, but in his post - PiotrC70 20:28:17 12/20/08 I love the gears, but they're a tad noisy - aliaZ 23:26:11 12/20/08 Is your gear noise at all speeds, or mainly betw. 60-70mph? - TTkeeper 11:00:02 12/21/08 mainly 60-70 mph - aliaZ 12:08:01 12/21/08 special order = 1 off sets. That will not happen. (n/m) - Bernie (NoVA) 01:41:02 12/21/08 I have a set new in box if anyone is looking. (n/m) - Bernie (NoVA) 01:39:03 12/21/08 Don't have to remove the abs sensors or sway bar - spyhunterTT(nj) 08:27:45 12/21/08
Post a Followup	You cannot reply to this message because you are not logged in.