Subject	I've found reinstalling the trans is the worst part.
Posted by	en5 on December 20, 2008 at 4:53 PM
	This message has been viewed 71 times.
In Reply To	Differential removed and ready for Leader Gears. posted by PiotrC70 on December 20, 2008 at 12:39 PM
Message	"Stabbing" the input shaft into the pilot bushing is not easy.
Follow Ups	Differential removed and ready for Leader Gears. - PiotrC70 12:39:29 12/20/08 I've found reinstalling the trans is the worst part. - en5 16:53:09 12/20/08 Using bolts with heads cut off as guides helps... - gunghoe9 17:00:36 12/20/08 timing belt idler studs also work well as guide pins (n/m) - aliaZ 18:05:10 12/20/08 Do it few times and it becomes easy :) (n/m) - Piranha(AZ) 17:18:42 12/20/08 No kidding! Pirahna witnessed my pattented 92 minute trans - nemo1080 (Iowa) 18:32:21 12/20/08 I thought they were discontinued? - BannonZ 18:32:47 12/20/08 they're not discontinued per Mark Leader (n/m) - aliaZ 18:46:53 12/20/08 just through SZ? (n/m) - BannonZ 18:48:31 12/20/08 SZ is the sole distributor - aliaZ 18:53:19 12/20/08 thought I saw a post here the other day, where Seb - BannonZ 19:01:27 12/20/08 Mark Leader responded to that same post (n/m) - aliaZ 19:27:16 12/20/08 You're correct. - PiotrC70 19:29:47 12/20/08 no - aliaZ 19:39:28 12/20/08 I could be misreading Marks reply as well, but in his post - PiotrC70 20:28:17 12/20/08 I love the gears, but they're a tad noisy - aliaZ 23:26:11 12/20/08 Is your gear noise at all speeds, or mainly betw. 60-70mph? - TTkeeper 11:00:02 12/21/08 mainly 60-70 mph - aliaZ 12:08:01 12/21/08 special order = 1 off sets. That will not happen. (n/m) - Bernie (NoVA) 01:41:02 12/21/08 I have a set new in box if anyone is looking. (n/m) - Bernie (NoVA) 01:39:03 12/21/08 Don't have to remove the abs sensors or sway bar - spyhunterTT(nj) 08:27:45 12/21/08
Post a Followup	You cannot reply to this message because you are not logged in.