TwinTurbo.NET: Nissan 300ZX forum - Differential removed and ready for Leader Gears.
People Seeking Info
 
   


     
Subject Differential removed and ready for Leader Gears.
     
Posted by PiotrC70 on December 20, 2008 at 12:39 PM
  This message has been viewed 221 times.
     
     
Message Forum member Gunghoe and I dropped my diff in preparation to be sent out for Leader Gear install. Per someones writeup which I can no longer find, it was REALLY simple.
1. Drop exhaust
2. Remove Driveshaft
3. Rotate rear wheels while removing all diff/shaft bolts (12 total)
4. Remove ABS sensors on each side of diff (2 bolts)
5. Remove rear sway bar.
6. Remove 2 (19mm) bolts on top rear of diff.
7. Remove 4 (17mm) bolts on cross-member supporting diff
8. Slide diff forward and down.
9. Wipe sweat from brow
10. Enjoy favorite beer. :o)

Next up for us is to drop the tranny to change seals and gaskets, delete EGR, and get the calipers powder coated in preparation for the 13" BBK.


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.