Subject	i "think" it was on the tranning side about 2-4 inches
Posted by	Halo Z on June 15, 2001 at 5:42 PM
	This message has been viewed 10 times.
In Reply To	Near the edges or in the middle usually? posted by SeedyRom on June 15, 2001 at 05:04 PM
Message	from the yoke. to u have to drop the h pipe and pull the DS down. that was on the stock one. i didn''t pay much attintion, we where repacing my center bearing at the time. RIC, my spelling sux, deal with it. AIM "NINnNINTY9" PS read the FAQ/TECH like a good Zer. Stupid people shouldn’t breed. the Halo tour, heading to TX this summer! FLA(Tampa), GA(Macon), & Tex(San Antonio)
Follow Ups	Found out why my powertrain driveshaft vibrates. - TwinTurboPete 15:40:53 06/15/01 How did you find out? Is it obvious? I need to check mine! (n/m) - SeedyRom 15:43:17 06/15/01 yeah u should be able to see a spot where it was - Halo Z 16:49:50 06/15/01 Near the edges or in the middle usually? - SeedyRom 17:04:32 06/15/01 i "think" it was on the tranning side about 2-4 inches - Halo Z 17:42:31 06/15/01 hummmmm - StEaMyZ(ZtoyZ.NET©) 15:55:23 06/15/01 The whole driveshaft was very dark except for one little - TwinTurboPete 18:02:56 06/15/01 I know what Ill be doing >>>> - StEaMyZ(ZtoyZ.NET©) 18:26:15 06/15/01 Had my Powertrain driveshaft balanced before I installed it. - MOTRSPRT--ID 17:05:03 06/15/01 How much did it cost? (n/m) - SeedyRom 17:27:15 06/15/01 I think Im going to pay powertrain a visit on my vacation - StEaMyZ(ZtoyZ.NET©) 17:56:54 06/15/01 Sure do. I have their STEEL version. - SeedyRom 18:16:31 06/15/01 $60. - MOTRSPRT--ID 11:03:42 06/16/01
Post a Followup	You cannot reply to this message because you are not logged in.