Subject	Hello everyone, it's been a month or two since I've been on
Posted by	93 Blue Z32(NC) on December 14, 2008 at 11:29 PM
	This message has been viewed 177 times.
Message	tt.net. Well, back in September one NA Z left my drive way, and then a week or two later a black tt arrived, the engine was removed and ordered parts and motor, etc. That Z finally left my driveway today. Also, I finely put my TT motor back into my own Z last week. When I get a radiator, ECU Upgrade, inter cooler brackets maybe I'll be able to drive my Z AFTER 4 YEARS before this month is over. I did a Z1 ECU upgrade on the black Z, I want to try someone else's ecu upgrade or ecu with software on my Z. What do you recommend? ">
Follow Ups	Hello everyone, it's been a month or two since I've been on - 93 Blue Z32(NC) 23:29:42 12/14/08 pic's after 4 years sitting, motors in - 93 Blue Z32(NC) 00:11:52 12/15/08 got like 5 of the same pic (n/m) - Nis300owner 00:36:12 12/15/08 are thouse washers big enough on the dp/testpipes? (n/m) - 300znick 01:19:51 12/15/08 I was able to use my buddy's shop with car lift, so I had to - 93 Blue Z32(NC) 09:31:16 12/15/08 pic - 93 Blue Z32(NC) 00:48:33 12/15/08 JWT, Ztuner or Nistune. Don't waste your time with AshSpec (n/m) - BigTDogg (MA) 07:09:52 12/15/08 Re: Hello everyone, it's been a month or two since I've been - txq45 08:42:47 12/15/08 BTW My o2 sensor bolt on the waste gate side and Maegan - 93 Blue Z32(NC) 10:08:48 12/15/08 O.k. I'm Interested in the Nistune. ??? - 93 Blue Z32(NC) 10:30:09 12/15/08 Re: O.k. I'm Interested in the Nistune. ??? - txq45 10:48:27 12/15/08 I'd go with JWT or AshSpec..... If you are looking for - nonstopna 11:45:33 12/15/08 Come fail away, come fail away, come fail away with meeeeeee (n/m) - BigTDogg (MA) 12:04:51 12/15/08 lol (n/m) - aliaZ 12:13:32 12/15/08 LOL x2!! (n/m) - Z_Cherub 12:23:42 12/15/08 ASH is running a christmas special with a 24hour promise or - ghostinator (fl) 20:29:47 12/15/08 And I wish him the best of luck - BigTDogg (MA) 21:39:55 12/15/08
Post a Followup	You cannot reply to this message because you are not logged in.