Subject	3-4 years here and probably 150-200+ motors, no issues
Posted by	SilverTwin(OH) on December 01, 2008 at 3:57 PM
	This message has been viewed 172 times.
In Reply To	I've used them on multiple motor pulls - no issues so far (n/m) posted by Bernie (NoVA) on December 01, 2008 at 03:20 PM
Message	Using the tabs on the side of the plenum scares me, I don't have as much faith in cast aluminum. I understand Damon's point about shear on the bolts when using the side tabs, it's not the bolts that concern me. The concept of the RameyZ sling came from similar designs used for decades on small and big block domestics which are much heavier. '91 TT Stage ??
Follow Ups	RameyZ Engine Sling - Madhatter10-6 13:28:46 12/01/08 hopefully it won't pull the threads out of the manifold - aliaZ 13:42:49 12/01/08 you're not alone - Dallas DamonZ 13:56:52 12/01/08 2nd - collegeboy 14:00:25 12/01/08 You are so lucky to live close to so many - KongZTT GT28RS MD 17:12:50 12/01/08 ask him about the ice cream ... (n/m) - Guapo 20:04:34 12/01/08 details details!! - KongZTT GT28RS MD 16:12:35 12/02/08 I agree - ZXRider(SoCal) 14:10:55 12/01/08 Figure 500lbs for the engine. 250 lbs per bolt on - AZHeat 14:41:15 12/01/08 I've used them on multiple motor pulls - no issues so far (n/m) - Bernie (NoVA) 15:20:14 12/01/08 3-4 years here and probably 150-200+ motors, no issues - SilverTwin(OH) 15:57:21 12/01/08 I had the same concerns, but I've used it a number of times - Guapo 16:41:39 12/01/08 Ive also used it many times with good results (n/m) - EricTTZ 22:25:36 12/01/08 Common sense would tell me if the holes I am pulling the - Spddracer 16:49:52 12/01/08 thats nice, but your common sense won't tell you - aliaZ 17:40:44 12/01/08 what? (n/m) - Guapo 20:04:11 12/01/08 I plan to use it on my next engine pull - S.Watson 14:29:29 12/01/08 Re: RameyZ Engine Sling - WazTTed 16:14:55 12/01/08 Re: what other goodies does Ramey Z make? - zgene4 17:45:27 12/01/08 Re: Re: what other goodies does Ramey Z make? - WazTTed 03:25:44 12/02/08 nylon ratchet tie down work well (n/m) - spyhunterTT(nj) 06:02:34 12/02/08
Post a Followup	You cannot reply to this message because you are not logged in.