Subject	I used high temp black spray paint.
Posted by	apudapus on November 19, 2008 at 3:44 PM
	This message has been viewed 37 times.
In Reply To	Alternative to powdercoating? posted by LivinTheDream on November 18, 2008 at 06:32 PM
Message	It'll chip off eventually but the valve covers are mostly covered up by the upper plenum. If you're going to care that much about how it looks, definitely pay the extra have it powder coated. *********************************
Follow Ups	Alternative to powdercoating? - LivinTheDream 18:32:15 11/18/08 I used high heat paint 3-4month later so far so good - SlowZ(SD) 18:42:48 11/18/08 Prep including.....??????? Primer??? (n/m) - LivinTheDream 19:27:39 11/18/08 Like this? - TriniTT 18:44:57 11/18/08 high temp paint is fine (n/m) - ali300zx 18:58:04 11/18/08 Bare aluminum looks good, just have to brush it up - BigTDogg (MA) 18:58:19 11/18/08 Looking good! (n/m) - Spongerider :) 19:06:14 11/18/08 Is that thing EVER going into the car? Or are you going to - Dave N 19:08:41 11/18/08 Baby steps... :-) (n/m) - BigTDogg (MA) 20:46:07 11/18/08 Very nice. Glad to see my $1 went to good use. :) (n/m) - Milo (SATX) 19:23:15 11/18/08 Why not powdercoat - collegeboy 19:15:51 11/18/08 From the Bahamas> - LivinTheDream 19:26:51 11/18/08 High temp paint is what I did and mine has a antique look - 5280Z_nightstalker 20:31:04 11/18/08 I used high temp black spray paint. - apudapus 15:44:27 11/19/08
Post a Followup	You cannot reply to this message because you are not logged in.