Subject	High temp paint is what I did and mine has a antique look
Posted by	5280Z_nightstalker on November 18, 2008 at 8:31 PM
	This message has been viewed 136 times.
In Reply To	Alternative to powdercoating? posted by LivinTheDream on November 18, 2008 at 06:32 PM
Message	I guess you can say. Just take paint stripper to clean off the stock coating and then wire wheel and your pretty much ready to paint. Good luck with whatever you choose.
Follow Ups	Alternative to powdercoating? - LivinTheDream 18:32:15 11/18/08 I used high heat paint 3-4month later so far so good - SlowZ(SD) 18:42:48 11/18/08 Prep including.....??????? Primer??? (n/m) - LivinTheDream 19:27:39 11/18/08 Like this? - TriniTT 18:44:57 11/18/08 high temp paint is fine (n/m) - ali300zx 18:58:04 11/18/08 Bare aluminum looks good, just have to brush it up - BigTDogg (MA) 18:58:19 11/18/08 Looking good! (n/m) - Spongerider :) 19:06:14 11/18/08 Is that thing EVER going into the car? Or are you going to - Dave N 19:08:41 11/18/08 Baby steps... :-) (n/m) - BigTDogg (MA) 20:46:07 11/18/08 Very nice. Glad to see my $1 went to good use. :) (n/m) - Milo (SATX) 19:23:15 11/18/08 Why not powdercoat - collegeboy 19:15:51 11/18/08 From the Bahamas> - LivinTheDream 19:26:51 11/18/08 High temp paint is what I did and mine has a antique look - 5280Z_nightstalker 20:31:04 11/18/08 I used high temp black spray paint. - apudapus 15:44:27 11/19/08
Post a Followup	You cannot reply to this message because you are not logged in.