TwinTurbo.NET: Nissan 300ZX forum - Well I'll be honest it's fairly difficult to mount a low
People Seeking Info
 
   


     
Subject Well I'll be honest it's fairly difficult to mount a low
     
Posted by en5 on November 13, 2008 at 2:30 PM
  This message has been viewed 100 times.
     
In Reply To I've had circumferential "scuffs" from them mounting the posted by Scotts94z32 on November 13, 2008 at 02:26 PM
     
Message profile tire on wheels 18"+ (low profile being 45 or less), it takes a pretty good amount of force, and the clamping pressure on the inside of the wheel just isn't good enough to stop the wheel from spinning on the clamps, and that's where the majority of the scratches come from.

The table rotates while you are putting the tire on, and if the tire hangs up while trying to mount it, the wheel stops but the table with clamps will still spin a bit and the clamps just tear up the inside. I've seen it happen a lot.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.