Subject	Looks great Joe
Posted by	jschrauwen on November 04, 2008 at 6:03 AM
	This message has been viewed 53 times.
In Reply To	Spddracer Front Splash Shield progress & Jspec Fitment. posted by Spddracer on November 03, 2008 at 08:01 PM
Message	So unless one has the J Spec Facia with the J Spec IC ducts, one needs to order just the generic one, correct? I'll wait for the classified post to order. Once again Joe, nice work. Judging by the pics, this will compliment my engine shield nicely. John 1990 TT 491.0 RWHP, 476.1 RWTQ, 18 PSI, 94 octane 26PSI w/Race gas = ???
Follow Ups	Spddracer Front Splash Shield progress & Jspec Fitment. - Spddracer 20:01:07 11/03/08 I am up for JSPEC version (n/m) - Tim B. 20:04:50 11/03/08 Nice!...but... - DVDBURN (MD) 20:55:40 11/03/08 AMS will only put their logo in the same place as his. - ni[X]it 20:58:54 11/03/08 Re: Spddracer Front Splash Shield progress & Jspec Fitment. - gclasse 21:41:28 11/03/08 most likely not. (n/m) - nemo1080 (Iowa) 22:18:56 11/03/08 what if you have the ash-spec massive ducts? (n/m) - blacktwin 23:53:30 11/03/08 Looks great Joe - jschrauwen 06:03:34 11/04/08 Basically yes. - Spddracer 06:29:59 11/04/08 Would it be terribly hard to modify the shields ourselves - FuerGrissa 08:09:15 11/04/08 Not really. Would require a bit of cutting it is all. - Spddracer 11:40:54 11/04/08 i am in for the jspec duct version, if you make them. - slayer fan 12:55:24 11/04/08 splash shield run - team7 17:26:10 11/04/08 Bulk buy? (n/m) - Spddracer 18:40:12 11/04/08
Post a Followup	You cannot reply to this message because you are not logged in.