Subject	Nice!...but...
Posted by	DVDBURN (MD) on November 03, 2008 at 8:55 PM
	This message has been viewed 186 times.
In Reply To	Spddracer Front Splash Shield progress & Jspec Fitment. posted by Spddracer on November 03, 2008 at 08:01 PM
Message	You've got to put a logo stamp on them so when they get copied by AMS people will know they have the real deal or not. (Total Mouse Over Hits: a Lot) www.mytwinturbo.com Watch an ECZA meet caravan!
Follow Ups	Spddracer Front Splash Shield progress & Jspec Fitment. - Spddracer 20:01:07 11/03/08 I am up for JSPEC version (n/m) - Tim B. 20:04:50 11/03/08 Nice!...but... - DVDBURN (MD) 20:55:40 11/03/08 AMS will only put their logo in the same place as his. - ni[X]it 20:58:54 11/03/08 Re: Spddracer Front Splash Shield progress & Jspec Fitment. - gclasse 21:41:28 11/03/08 most likely not. (n/m) - nemo1080 (Iowa) 22:18:56 11/03/08 what if you have the ash-spec massive ducts? (n/m) - blacktwin 23:53:30 11/03/08 Looks great Joe - jschrauwen 06:03:34 11/04/08 Basically yes. - Spddracer 06:29:59 11/04/08 Would it be terribly hard to modify the shields ourselves - FuerGrissa 08:09:15 11/04/08 Not really. Would require a bit of cutting it is all. - Spddracer 11:40:54 11/04/08 i am in for the jspec duct version, if you make them. - slayer fan 12:55:24 11/04/08 splash shield run - team7 17:26:10 11/04/08 Bulk buy? (n/m) - Spddracer 18:40:12 11/04/08
Post a Followup	You cannot reply to this message because you are not logged in.