Subject	The reason you do NOT do it this way is...
Posted by	SeedyRom on June 13, 2001 at 6:32 PM
	This message has been viewed 11 times.
In Reply To	Found out how to install gauges w/out removing needles... posted by HawaiiZ on June 13, 2001 at 05:47 PM
Message	You can potentially BREAK the needle when you lift it up. I had asked a guy at NR about this before I found my cluster in the junkyard (!) and he mentioned that it was possible, but some needles are very brittle and can snap that way. Also, at the base of the needle where it attaches to the round "knob" like black part, it can separate there as well. There is no EASY answer here...if you do it, know the risks :) Good luck! Vote on my Z on www.cardomain.com! Fords are killing us! Zheaven.com is back *UP* completely! 04/13/01 -- Click my Z below to enter.
Follow Ups	Found out how to install gauges w/out removing needles... - HawaiiZ 17:47:22 06/13/01 hmmm.....looks good BUT - StEaMyZ(ZtoyZ.NET©) 17:54:35 06/13/01 nor does the Z column tilt :-) (n/m) - toyluvr 17:57:43 06/13/01 The instructions weren't for a Z... - MikeM317 (Boston) 20:24:21 06/13/01 AHHHH!!The old big hole in the guage trick!>> - wild300 17:56:08 06/13/01 The reason you do NOT do it this way is... - SeedyRom 18:32:52 06/13/01 it seems that this 1 is the lesser of 2 evils... (n/m) - HawaiiZ 19:20:46 06/13/01 Perhaps... - SeedyRom 19:31:02 06/13/01 THose gauges look better than APC, but no boost/oil gauges? (n/m) - teahead 22:16:01 06/13/01 You realize thats not a ZX right? (n/m) - YugoBernie (NoVA) 22:56:32 06/13/01 Re: The reason you do NOT do it this way is... - tahoang 23:40:08 06/13/01
Post a Followup	You cannot reply to this message because you are not logged in.