| Remove the panels and bolt the bar in place. Then take measurements using some point that won't change. I used the back edge of the interior panels behind the seats and the package tray . To get the side cuts, measure from the front panels to the front and rear edge of the Carbing bar. Then do the same thing for the top cut. Measure from the package tray to the top of the Carbing bar. Take the bar back out, put the 2 panels back into place. Put some tape on them so that you have something to draw on. Then just transfer the measurements. Take the panels back out, reinstall bar. Start cutting the panels. Cut the opening smaller to begin with and lay the panels into place over the bar to check your progress and to make sure you got things right.
JackB nimble JackB quick JackB can suck my dick =P - james-lee 11/02/01
Arrogance is the #1 weapon against Supra Owners - MikeH 08/06/02
Dallas with a Z: I like the bulge dude 05/02/03
Bezbefootball: Does dick have anything for me? 10/21/03 |
