TwinTurbo.NET: Nissan 300ZX forum - They look like GT2560's with the OE comp housing machined
People Seeking Info
 
   


     
Subject They look like GT2560's with the OE comp housing machined
     
Posted by Ash's Z on September 24, 2008 at 10:29 PM
  This message has been viewed 110 times.
     
In Reply To sorry guys posted by Xtrm300zx on September 24, 2008 at 02:36 AM
     
Message to fit since the 2560 turbos have a different bolt pattern. Chip was probably just buying the cartridge and turbine housing and then having OE comp housings bored for the wheel to simplify installation.

The only "sure" way to tell would be to remove both the turbine and compressor housing and measure the inducer and exducer diameters of the compressor and turbine wheel.




[ ashspecz.com ]
[ agpowers@bellsouth.net ]

Enthusiasts soon understand each other. --W. Irving.
Are you an enthusiast?

If you are out to describe the truth, leave elegance to the tailor.
Albert Einstein

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.