Subject	A cheap and easy way to find out is to head down to your
Posted by	Agner.S(CT) on September 19, 2008 at 5:34 PM
	This message has been viewed 50 times.
In Reply To	Dyno Bet help...:P posted by ouikikazz on September 19, 2008 at 08:08 AM
Message	local drag strip and do a run or two and note down your mph. On the Z anything over 112 should be 360+ Rwhp. On a side note at 1 bar I made 350+ rwhp with stock intercoolers and crank pulley. Sexpelled
Follow Ups	Dyno Bet help...:P - ouikikazz 08:08:18 09/19/08 ditch the boost jets and get a EBC - Drk93TT 08:25:33 09/19/08 if you get an EBC, set it up to spike around 19-20 and then - itsghoZt 15:02:09 09/19/08 dyno type - guineaG60 19:55:35 09/19/08 2nd what Drk93TT said, and you should have bet him on torque - BigTDogg (MA) 08:30:26 09/19/08 Actually, I take that back, both of my dynos were at - BigTDogg (MA) 08:55:50 09/19/08 I reckon 350-360rwhp is the upper limit at 15psi on stockers (n/m) - Bezza 08:51:01 09/19/08 2nd U loose. (n/m) - REDI4U 09:18:08 09/19/08 install the ebc and you should get a free dyno session - Craig300ZX 09:19:06 09/19/08 run open down pipes no other exhaust get a boost - dream Z (MD) 09:20:29 09/19/08 That's a good way to damage your starter & trans harness. (n/m) - Bernie (NoVA) 09:30:09 09/19/08 Bah. Those are overrated anyway. (n/m) - na300zx (OH) 09:57:19 09/19/08 Your need to.... - The Hawk 09:56:57 09/19/08 Re: Your need to.... - ouikikazz 16:57:26 09/19/08 Sounds like you should run 100 octane. - Scotts94z32 10:06:45 09/19/08 2nd on the 100 octane (n/m) - Drk93TT 11:05:00 09/19/08 Depends on the dyno and the corrections... (n/m) - Fly-Surf 10:16:46 09/19/08 close, probably more like 340hp - Jonez 11:20:58 09/19/08 I did 348 rwhp with full cats and precats at that - AZHeat 11:49:46 09/19/08 More details? (n/m) - Spongerider :) 12:24:27 09/19/08 I had JWT stage III chip, and cat back, JWT intake. - AZHeat 12:44:15 09/19/08 dam not bad - ricky6991 13:00:41 09/19/08 Going from that I did gutted precats and test pipes - AZHeat 13:22:14 09/19/08 yeah i think i read 6400 is our max tourqe/hp stock. (n/m) - ricky6991 14:06:02 09/19/08 A cheap and easy way to find out is to head down to your - Agner.S(CT) 17:34:19 09/19/08 Your Mods aren't that different than mine... - gunghoe9 19:57:01 09/19/08 Oops, I meant Dynapak (n/m) - gunghoe9 20:14:46 09/19/08
Post a Followup	You cannot reply to this message because you are not logged in.