TwinTurbo.NET: Nissan 300ZX forum - if you get an EBC, set it up to spike around 19-20 and then
Subject
if you get an EBC, set it up to spike around 19-20 and then
Posted by
itsghoZt
on September 19, 2008 at 3:02 PM
This message has been viewed
63
times.
In Reply To
ditch the boost jets and get a EBC
posted by Drk93TT
on September 19, 2008 at 08:25 AM
Message
have it hold at 17psi-18psi, use some race gas and mess with the timing a little, this will render some more power.
Follow Ups
Dyno Bet help...:P
-
ouikikazz
08:08:18 09/19/08
ditch the boost jets and get a EBC
-
Drk93TT
08:25:33 09/19/08
if you get an EBC, set it up to spike around 19-20 and then -
itsghoZt
15:02:09 09/19/08
dyno type
-
guineaG60
19:55:35 09/19/08
2nd what Drk93TT said, and you should have bet him on torque
-
BigTDogg (MA)
08:30:26 09/19/08
Actually, I take that back, both of my dynos were at
-
BigTDogg (MA)
08:55:50 09/19/08
I reckon 350-360rwhp is the upper limit at 15psi on stockers (n/m)
-
Bezza
08:51:01 09/19/08
2nd U loose. (n/m)
-
REDI4U
09:18:08 09/19/08
install the ebc and you should get a free dyno session
-
Craig300ZX
09:19:06 09/19/08
run open down pipes no other exhaust get a boost
-
dream Z (MD)
09:20:29 09/19/08
That's a good way to damage your starter & trans harness. (n/m)
-
Bernie (NoVA)
09:30:09 09/19/08
Bah. Those are overrated anyway. (n/m)
-
na300zx (OH)
09:57:19 09/19/08
Your need to....
-
The Hawk
09:56:57 09/19/08
Re: Your need to....
-
ouikikazz
16:57:26 09/19/08
Sounds like you should run 100 octane.
-
Scotts94z32
10:06:45 09/19/08
2nd on the 100 octane (n/m)
-
Drk93TT
11:05:00 09/19/08
Depends on the dyno and the corrections... (n/m)
-
Fly-Surf
10:16:46 09/19/08
close, probably more like 340hp
-
Jonez
11:20:58 09/19/08
I did 348 rwhp with full cats and precats at that
-
AZHeat
11:49:46 09/19/08
More details? (n/m)
-
Spongerider :)
12:24:27 09/19/08
I had JWT stage III chip, and cat back, JWT intake.
-
AZHeat
12:44:15 09/19/08
dam not bad
-
ricky6991
13:00:41 09/19/08
Going from that I did gutted precats and test pipes
-
AZHeat
13:22:14 09/19/08
yeah i think i read 6400 is our max tourqe/hp stock. (n/m)
-
ricky6991
14:06:02 09/19/08
A cheap and easy way to find out is to head down to your
-
Agner.S(CT)
17:34:19 09/19/08
Your Mods aren't that different than mine...
-
gunghoe9
19:57:01 09/19/08
Oops, I meant Dynapak (n/m)
-
gunghoe9
20:14:46 09/19/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.